Plant Biology
Objectives/Goals Evolutionary relationships within the Class Phaeophyceae (brown algae) have long been a source of discussion and speculation. Previously the Orders Ectocarpales and Scytosip…
Zoology
Objectives/Goals My objective is to investigate an alternative to chemical mosquito control and further study how motion disturbance of water affects the development of mosquito larvae into…
Aerodynamics/ Hydrodynamics
Objectives/Goals My objective was to find the exact degree of angle of attack that a plane would stall. Methods/Materials i built a wind tunnel that got 30 mph in the test section (where the…
Microbiology
Objectives/Goals The objective of the experiment was to isolate the chemical fraction in which the bioactive ingredient of Arctostaphylus was located. Methods/Materials In the preliminary te…
Environmental Engineering
Objectives/Goals The objective is to deduce the grazing rates of the toxic algal bloom, the isolation and culturing of the algea by using protozoan communities, and the usage of mescocosm ex…
Pharmacology/ Toxicology
Objectives/Goals The objective is to find the effect of different solutions of auxin on three species of monocots and three species of dicots. Specifically, I will be observing seedlings. Me…
Pharmacology/ Toxicology
Objectives/Goals I read a short article which discussed why the skin wrinkles in water. I wondered, would the skin on a finger "wrinkle" at the same rate in ocean water as it did in fresh wa…
Zoology
Objectives/Goals The objective of my project was to find out which food's scent trail on a certain surface would cause a rat to follow it through a maze quicker than the scent trails of all…
Microbiology
Objectives/Goals My objective was to learn who had the most bacteria, cats or dogs. Methods/Materials I contacted and collected dog and cat samples from T.H. Veterinary. Gathered materials n…
Microbiology
Objectives/Goals Problem: Does drive-thru ice have a higher level of bacterial contamination than self-serve machine ice in fast food restaurants? Hypothesis: The drive-thru ice will exhibit…
Microbiology
Objectives/Goals My objective is to determine the amount of bacteria in refrigerated and standing milk to see if it is unsafe or safe to drink by using the Methylene Blue Test. Growing bacte…
Microbiology
Objectives/Goals My hypothesis is that water near the information center will be more polluted with E. coli and coliform bacteria the closer one gets to the storm drain. I am testing the lev…
Microbiology
Objectives/Goals The objective of my experiment is to compare the bacteriostatic and bactericidal effectiveness of first, second and third generation antibiotics on Staphylococcus epidermidi…
Microbiology
Objectives/Goals To find out if a dog, cat, or human has the most bacteria in its saliva. Methods/Materials Foil; wooden box; insulation, board; thermometer; 40 watt light bulb; lamp; electr…
Applied Mechanics/ Structures & Mechanisms/ Manufacturing
Objectives/Goals My project is to determine the relationship between the stretching of a rubber band and how far and fast an object would travel. In the process, I am investigating the relat…
Applied Mechanics/ Structures & Mechanisms/ Manufacturing
Objectives/Goals My objective is to determine which bat alloy can hit the bat the farthest. Methods/Materials The materials needed to accomplish this experiment are; nine numbered flags, a b…
Social Sciences (Junior Division Only)
Objectives/Goals The "Battle of the Beverage" was conducted to see if product packaging influenced a consumer's purchase of colas. I was trying to prove the hypothesis that product packaging…
Pharmacology/ Toxicology
Objectives/Goals The purpose of this experiment was to show that hair dye is damaging. The experiment was performed in order to demonstrate the weakening powers of dying one's hair. Methods/…
Physics & Astronomy
Objectives/Goals My project evaluated liquid and solid scintillation to determine the feasibility of using these methods to detect trace levels of fluvial radioactivity. After doing research…
Zoology
Objectives/Goals The objective is to identify any environmental, physical or biological factors that influence the larval settlement of marine invertebrates inhabiting the intertidal zone. T…
Social Sciences (Junior Division Only)
Objectives/Goals The project objective is to determine whether it is easier to recognize a familiar face by looking at a photo showing the top half of the face versus the bottom half. Method…
Physics & Astronomy
Objectives/Goals The objective of the project was to test the effectiveness of various types of earplugs using a Vernier decimeter to detect how much sound the earplugs blocked. Methods/Mate…
Pharmacology/ Toxicology
Objectives/Goals The objective is to determine if caffeine effects the blood pressure of children. Methods/Materials Eight subjects ages 9-15 were used in the project. The blood pressure of…
Environmental Engineering
Objectives/Goals We are using up all our trees to make paper and soon we will start to run out of trees. I want to know if I can find a sustainable paper source that can be used to make writ…
Chemistry
Objectives/Goals My objective was to determine whether a solution with a greater salinity would yield more hydrogen through hydrolysis than a solution with a lower salinity using a homemade…
Mammalian Biology
Objectives/Goals My objective is to find out if dogs have a color preference by sight.(They are not color blind) Methods/Materials To test my theory, I chose 10 dogs, 4 colored tennis balls,…
Behavioral Sciences
Objectives/Goals My project was to determine if twenty minutes of exposure to fifty degree temperatures would effect subject's ability to perform basic mental and physical tests. My hypothes…
Behavioral Sciences
Objectives/Goals Humans possess the important ability to communicate and perform mental activities by using elaborate language. Bilingual people have the option to perform those activities i…
Electricity & Electronics
Objectives/Goals The main goal of this project is to demonstrate the feasibility of building a low-cost Brain Computer Interface (BCI) for electronic control of devices using Electroencephal…
Structural Capability & Strength of Materials (Junior Division Only)
Objectives/Goals This experiment was to determine if it is possible to make a lighter yet stronger brick than one made of ordinary concrete. My goal was to modify the curing technique and th…